SX NISSAN 240 1998 2DR HATCHBACK
Security
Battery WHT + (+) IGNITION SWITCH HARNESS
Ignition BLK/RED (+) IGNITION SWITCH HARNESS
Starter01 BLK/YEL + (+) IGN SW HAR
AllDoorTrigger RED/WHT (-) (-) DRIVER'S KICK PANEL
TrunkTrigger RED (-) (-) AT ANTI-THEFT MODULE
FactoryAlarmDisarm GRN/YEL (-) DRIVERS KICK
ParkingLights RED/BLU (+) SWITCH ON DRIVERS KICK
Remote Start
Battery WHT + (+) IGNITION SWITCH HARNESS
Ignition BLK/RED (+) IGNITION SWITCH HARNESS
Ignition02 WHT + (+) IGNITION SWITCH HARNESS
Ignition03 WHT + IGNITION SWITCH HARNESS
Accessory01 WHT/BLU + (+) IGNITION SWITCH HARNESS
Accessory02 +
Starter01 BLK/YEL + (+) IGN SW HAR
AntiTheftSystem NONE
NeutralSafety ORG/YEL (-)
Tach YEL/RED (-) (-) AT ECM PASS KICK 120 PIN CONN POS 3
SpeedSense YEL/GRN 2000 (AC) ECM PASSENGERS KICK
ParkingLights RED/BLU (+) SWITCH ON DRIVERS KICK
BrakeLights RED/GRN (+) AT BRAKE SWITCH
ReverseLights RED (AUTO) (+) GRN/WHT (MANUAL)DRIVERS KICK
Horn GRN/WHT (-) UNDER DAS DRIVERS SIDE
Doorlocks / Window
PowerUnLock BRN (-) (-) PIN 18 AT SECU MODULE
PowerLock LT.BLU/WHT(-) (-) SECU DRIVERS KICK NEGATIVE TRIGGER
LeftFrontWindow01 RF:RED/WHT
RightFrontWindow01 LF:GRN
LeftRearWindow01 RF:RED/BLK
RightRearWindow01 LF:BLU
Convenience
HeadLights RED/YEL L AND RED/BLU R AT IGNITION SWITCH HARNESS
LowSpeedWipers LT.GRN/RED(-) (-) AT SWITCH
TrunkRelease N/A
HATCHBACK
Mobile Audio / Video
Battery WHT + (+) IGNITION SWITCH HARNESS
Accessory01 WHT/BLU + (+) IGNITION SWITCH HARNESS
Ground GRY - (-) RADIO HARNESS
Illumination RED/BLU (+) RADIO HARNESS
Dimmer RED/YEL (+) RADIO HARNESS
PowerAntenna GRN/WHT (+) RADIO HARNESS
FrontLeftSpeakerPos PNK
FrontLeftSpeakerNeg BLU
FrontRightSpeakerPos WHT
FrontRightSpeakerNeg BLACK
RearLeftSpeakerPos LT.GRN
RearLeftSpeakerNeg VIO
RearRightSpeakerPos BLU
RearRightSpeakerNeg PNK
Amp NOT LIKELY
Control Modules
Note:
Wirediagram.com makes no representation or warranty with respect to the above information including its accuracy, completeness, or its freedom from third parties' proprietary rights. Wirediagram.com disclaims all liability or responsibility for errors or omissions therein or any decision made by the recipient in reliance thereon. The installer must verify any circuitry with the proper test equipment prior to installation.
