1997 HYUNDAI ELANTRA 4DR SEDAN
Security
Battery BLU/RED + (+) IGNITION SWITCH HARNESS
Ignition BLK/WHT (+) IGNITION SWITCH HARNESS
Starter01 YEL/BLK + (+) IGNITION SWITCH HARNESS
AllDoorTrigger YEL (-) (-) ANY PIN SWITCH OR BLK/RED BEHIND INST.
TrunkTrigger BLU/YEL (-) (-) DRIVERS RUNNING BOARD
ParkingLights GRN/WHT (-) (-) 8 PIN BLK CONN ON LIGHT SWITCH
Remote Start
Battery BLU/RED + (+) IGNITION SWITCH HARNESS
Ignition BLK/WHT (+) IGNITION SWITCH HARNESS
Ignition02 BLU/BLK + (+) OR WHT/BLU IGN SWITCH HARNESS
Ignition03 +
Accessory01 BLU/YEL + (+) OR RED/WHT IGN SWITCH HARNESS
Accessory02 +
Starter01 YEL/BLK + (+) IGNITION SWITCH HARNESS
AntiTheftSystem NONE
Tach BLU/YEL (AC) IGNITION MODULE DRIVERS SIDE
SpeedSense YEL/WHT 4000 (AC) DR.KICK SINGLE PLUG POS 42 ECM
ParkingLights GRN/WHT (-) (-) 8 PIN BLK CONN ON LIGHT SWITCH
BrakeLights GRN (+) (+) LEFT OF STEERING COLUMN OR RUNNING BOARD
ReverseLights RED/GRN (+) (+) RUNNING BOARD HARNES DRIVERS SIDE
Horn BLK/WHT (-) STEERING COLUMN
Doorlocks / Window
PowerUnLock N/A
PowerLock N/A NEED ACTUATOR
Doorlocks / Windows
Power UnLock
ADD AN ACTUATOR
PowerLock
ADD AN ACTUATOR
Convenience
HeadLights RED/YEL (-) (-) STEERING COLUMN
TrunkRelease YEL/BLK (+) OR YEL AT SWITCH
Mobile Audio / Video
Battery BLU/RED + (+) IGNITION SWITCH HARNESS
Accessory01 BLU/YEL + (+) OR RED/WHT IGN SWITCH HARNESS
Ground BLK - (-) RADIO HARNESS
Illumination DK.GRN/WHT (+) RADIO HARNESS
Dimmer DK.GRN/BLK (+) RADIO HARNESS
FrontLeftSpeakerPos GRN/RED
FrontLeftSpeakerNeg LT.GRN/WHT
FrontRightSpeakerPos RED/BLU
FrontRightSpeakerNeg LIGHT GREEN/BLACK
RearLeftSpeakerPos YEL/WHT
RearLeftSpeakerNeg YEL/BLU
RearRightSpeakerPos GRN
RearRightSpeakerNeg GRN/BLU
Control Modules
Note:
Wirediagram.com makes no representation or warranty with respect to the above information including its accuracy, completeness, or its freedom from third parties' proprietary rights. Wirediagram.com disclaims all liability or responsibility for errors or omissions therein or any decision made by the recipient in reliance thereon. The installer must verify any circuitry with the proper test equipment prior to installation.
