1999 CADILLAC ELDORADO 2DR COUPE
Security
Battery RED (2) + (+) IGNITION SWITCH HARNESS
Ignition PNK (+) IGNITION SWITCH HARNESS
Starter01 YEL + (+) IGNITION SWITCH HARNESS
AllDoorTrigger WHT (-) (-) COURTESY LIGHTOR VIO SEC MOD IN TRUNK
TrunkTrigger DK.GRN (-) (-) DRIVER'S KICK PANEL
FactoryAlarmDisarm LT.GRN (-) DRIVER'S KICK PANEL
ParkingLights VIO (+) (+) DRIVERS KICK PANEL OR RELAY IN TRUNK
Remote Start
Battery RED (2) + (+) IGNITION SWITCH HARNESS
Ignition PNK (+) IGNITION SWITCH HARNESS
Ignition02 LT.BLU + (+) IGNITION SWITCH HARNESS
Ignition03 +
Accessory01 ORG + (+) IGNITION SWITCH HARNESS (HEAT/A.C.)
Accessory02 +
Starter01 YEL + (+) IGNITION SWITCH HARNESS
AntiTheftSystem NONE
KeySense LT.GRN (-) (-) STEERING COLUMN HARNESS
Tach WHT (-) PCM DRIVERS FRONT OF ENG.UNDER AIR CLEAN
ParkingLights VIO (+) (+) DRIVERS KICK PANEL OR RELAY IN TRUNK
BrakeLights LT.BLU (+) (+) OR WHT AT SWITCH
ReverseLights LT.GRN (+) SWITCH ON TRANS.
Horn BLK (-) STEERING COLUMN
Doorlocks / Window
PowerUnLock ORG/BLK (-) (-) NEGATIVE TRIGGER
PowerLock RED/BLK (-) (-) DR. KICK PANEL OR BCM BEHIND REAR SEAT
LeftFrontWindow01 LF:LT.BLU
RightFrontWindow01 RF:LT.BLU (DRIVERS)
LeftRearWindow01 LF:BRN
RightRearWindow01 RF:TAN (SWITCH)
Convenience
HeadLights YEL (-) (-) HEADLIGHT SWITCH
TrunkRelease BLK (-) (-) TRUNK RELEASE SWITCH
Mobile Audio / Video
Battery RED (2) + (+) IGNITION SWITCH HARNESS
Accessory01 ORG + (+) IGNITION SWITCH HARNESS (HEAT/A.C.)
Ground BLK - (-) RADIO HARNESS
Illumination GRY (+) RADIO HARNESS
Dimmer BRN (+) RADIO HARNESS
PowerAntenna PNK (+) RADIO HARNESS
FrontLeftSpeakerPos TAN
FrontLeftSpeakerNeg GRY
FrontRightSpeakerPos LT.GRN
FrontRightSpeakerNeg DARK GREEN
RearLeftSpeakerPos BRN
RearLeftSpeakerNeg YEL
RearRightSpeakerPos DK.BLU
RearRightSpeakerNeg LT.BLU
Control Modules
SEC MODULE IN TRUNK
Note:
Wirediagram.com makes no representation or warranty with respect to the above information including its accuracy, completeness, or its freedom from third parties' proprietary rights. Wirediagram.com disclaims all liability or responsibility for errors or omissions therein or any decision made by the recipient in reliance thereon. The installer must verify any circuitry with the proper test equipment prior to installation.
