1998 KIA SEPHIA 4DR SEDAN
Security
Battery WHT + (+) IGNITION SWITCH HARNESS
Ignition BLK/WHT (+) IGNITION SWITCH HARNESS
Starter01 BLK/YEL + (+) IGNITION SWITCH HARNESS
AllDoorTrigger RED/YEL (-) (-) AT TIMER HIGH IN DRIVER'S KICK
TrunkTrigger BLU (-) (-) AT TRUNK LIGHT
FactoryAlarmDisarm GRN IGN HARNESS
ParkingLights RED/BLK (+) (+) REAR OF DIMMER
Remote Start
Battery WHT + (+) IGNITION SWITCH HARNESS
Ignition BLK/WHT (+) IGNITION SWITCH HARNESS
Ignition02 BLU/RED + (+) IGNITION SWITCH HARNESS
Ignition03 +
Accessory01 BLK/RED + (+) INGITION SWITCH HARNESS
Accessory02 +
Starter01 BLK/YEL + (+) IGNITION SWITCH HARNESS
AntiTheftSystem NONE
Tach YEL (AC) AT COIL ON LEFT INNER FENDER
SpeedSense GRN/RED 4000 (AC) ABOVE PASS FEET 20 PIN CONN
ParkingLights RED/BLK (+) (+) REAR OF DIMMER
BrakeLights GRY/BLK (+) (+) AT BRAKE SWITCH
Horn GRN/ORN (-) AT TIMER LEFT OF KICK PANEL
Doorlocks / Window
PowerUnLock ACTUATOR
PowerLock ACTUATOR
LeftFrontWindow01 LF:RED
RightFrontWindow01 RF:RED/YEL LR:RED/BLU RR:RED/WHT
LeftRearWindow01 LF:GRN
RightRearWindow01 RF:GRN/YEL LR:BLU/WHT RR:GRN/WHT
Doorlocks / Windows
Power UnLock
ADD AN ACTUATOR
PowerLock
ADD AN ACTUATOR
Convenience
HeadLights RED/WHT (+) (+) AT LIGHT SWITCH "LOW BEAM ONLY"
Mobile Audio / Video
Mobile Audio / Video
Battery WHT + (+) IGNITION SWITCH HARNESS
Accessory01 BLK/RED + (+) INGITION SWITCH HARNESS
Ground BLK - (-) RADIO HARNESS
Illumination BLU/WHT + (+) RADIO HARNESS
FrontLeftSpeakerPos WHT/BLK
FrontLeftSpeakerNeg WHT/GRN
FrontRightSpeakerPos YEL/RED
FrontRightSpeakerNeg YELLOW/WHITE
RearLeftSpeakerPos BRN/GRN
RearLeftSpeakerNeg BRN/BLK
RearRightSpeakerPos LT GRN/RED
RearRightSpeakerNeg LT GRN/YEL
Amp NOT LIKELY
Control Modules
Note:
Wirediagram.com makes no representation or warranty with respect to the above information including its accuracy, completeness, or its freedom from third parties' proprietary rights. Wirediagram.com disclaims all liability or responsibility for errors or omissions therein or any decision made by the recipient in reliance thereon. The installer must verify any circuitry with the proper test equipment prior to installation.
